Immediately before removing the protective material from the leads of a replacement ES device, touch the protective material to the chassis or circuit assembly into which the device will be installed. The versatility of the Amplifier makes it the perfect choice for almost every type of custom multi-room More information. This guide More information. The main printed More information. Tools you need You need a small Phillips screwdriver and. Encoder Wires attached Not Shown 1: The versatility of the Amplifier makes it the perfect choice for almost every type of custom multi-room.
|Date Added:||21 November 2011|
|File Size:||61.50 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
The rating label on the device provides the class A or B of the equipment. The following techniques should be used to help reduce the incidence of component damage caused by electrostatic discharge ESD.
Televisions in Hurghada – Other
With the switch from analog to digital technology, Cable ONE will be able lcr add new channels, especially more HD channels, and. After removing an electrical assembly equipped with ES devices, place the assembly on a conductive surface such as aluminum foil, to prevent electrostatic charge buildup or exposure of the assembly.
In order to display the Hotel mode setup menu, please enter the following command within 2 second. Screw in the positions indicated using the specified torque. Take care not to tap or scratch with your fingernail or other hard objects. Do not press panel surface to avoid blue spot on the panel display.
Press the tape so it is properly stuck down. Excellent value More information. Register your product and get support at. Do not use hard cloth or rub the surface too hard.
Plug the AC cord directly into the AC outlet. Using a Digital Multimeter 4. Remove the barrier tape protector. During this operation do not pull, just align and connect. Contents When an abnormality occurs, the protection circuit will operate and reset the unit to stand by mode. Access command to the Hotel mode setup menu. Take care not to subject the TV s surface to water or detergent. Use only a grounded-tip soldering iron to solder or unsolder ES devices.
Purpose Restrict a function for hotels.
Class B devices have a Federal Communications More information. After applying PbF solder to double layered km155, please check the component side for excess solder which may flow onto the opposite side. Insert the speaker in the speaker brackets. Bottom Cover Assembly Insert the bottom cover guides into the grooves on the lower metal part and slide the lower part in the direction indicated.
The dotted lines indicate the panel guides: The versatility of the Amplifier makes kn15 the perfect choice for almost every type of custom multi-room More information.
TABLE OF CONTENTS LCD TV. Model No. TC-L32X5 Chassis: KM15 Destination: USA
Unplug the AC cord and connect a jumper between the two prongs on the plug. Read this operation manual. It describes the monitor’s More information.
If the unit does not have a remote controller the fault will. This indication will not be cleared by either of the self-checks or any other command Exit.
TABLE OF CONTENTS LCD TV. Model No. TC-L32X5 Chassis: KM15 Destination: USA – PDF
Set the input, when each time power is switched on. Checking the IIC bus lines 2. Plate Metal Part Assembly.