Page 4 Section 8: Repair and Parts Replacement By pressing ‘print’ button you will print only current page. Enter text from picture: General Information Page 6 – Section 2: Because the scale uses special low-power circuitry, no warm-up time is required. Page 11 Section 4:

Uploader: Mikagar
Date Added: 7 February 2005
File Size: 29.65 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 74535
Price: Free* [*Free Regsitration Required]

Page 2 Every effort has been made to provide complete and accurate information in this manual.

Using the level bubble, adjust one or two feet minimally to level the platform. Sealing The Scale Section 6: Customer Care Page 11 Page 12 – Section 5: IF you are using a remote display, check the main display first, if it’s OK then check the cable and plug connection on the remote First unplug, then plug in the AC adapter to reset the program.

It uses default Windows drivers and is installed automatically upon first connection with a PC. Page 15 Section 6: Do NOT adjust all 4 feet. A low power USB device draws less than mA.


Fairbanks Ultegra SCB-R9000-14U Service Manual

The breakdown of the zones are as follows: Press the [ZERO] key to zero the scale. Computer Connections Section 2: To print the manual completely, please, download it. Corner Test Section 6: If the corners are not within one 1 division of each farbanks, conduct a good visual inspection to verify that there are no binds or interference with the platform and re test the scale.

Using the Scale 3.

The maximum USB cable length is 5 meters unless a self powered hub is used to extend the cable length. Calibrate the scale Section 6 Note: Repair and Parts Replacement Page 17 Section 6: Don’t show me this message again.

Page 16 The scale must be calibrated if you proceed past this step. Screw in all 4 feet, set upright and re-level All equipment should be sclaes from direct sunlight.


Disconnect power to the scale 2. Zone Latitude degrees Reference City Display Assembly Replacement Section 7: Enter text from picture: Scale instrument, modular designed instrument, configurable and upgradable using printed circuit modules pages.


Scale will display “”, when power is turned on and weight is present. Table of Contents Add to my manuals Add. Page 4 Section 8: Turn the unit upside down and remove all four feet from the scale platform 3.

If the corners are still not within one 1 division of each other, identify the corner s with the error and replace the load cell in that corner. Parts Page 23 Page 24 – Appendix I: